If you know what you're doing, and the box has done over 300,000km it doesn't hurt to throw in a new set of bearings as preventative maintenance.
Based on a box not showing any signs of problem or...
If you know what you're doing, and the box has done over 300,000km it doesn't hurt to throw in a new set of bearings as preventative maintenance.
Based on a box not showing any signs of problem or...
G`day Dom
Sorry this is a bit late but I`m in the middle of WA and the coverage is sparse.
Looking at your problem,the master cylinder is leaking past the rear seal.
I would suggest that a new...
Installation of the new is pretty much the reverse of the above.
Precautions:
1)Use almost same diameter socket as the uni joint cap to hit the caps. Do not hit with a round head hammer.
...
You take the hinge off - grind off the bottom of the pin - punch the pin out - separate the two parts of the hinge - cut the tops off the bushes - punch out the old bushes - press in new bushes - put...
how did you end up doing it mate. Just wondering so we can see if you did it right or wrong.
What valve clearance did you set?
Are you sure you were on TDC on the compression stroke and not on...
I always found the easiest way was to remove the Glow Plug from N#1
scrunch up a tissue, and plug that in the Glow Plug hole
wind over - by hand - the Crank or the Power Steering pulleys
when the...
I would try disconnecting the battery for a few hours and also letting it dry out preferably overnight. Then give it a try. If still the same I think you will have to get the codes read? Not much...
Obviously you have to fix the IC but the CRD's have plenty of go standard especially with a better exhaust.
It took me a while getting used to the 3l especially after having a V8 but once learning...
The very first mods before anything suggested above:
Get decent quality EGT and Boost Gauges!
If don't know what your boost and EGT's are doing then you flying blind. It doesn't matter if a DI or...
with my old GQ,
I added a heap or extra Earth Cables, and never had any more electrical gremlins
I used standard gauge Battery Earth Cables
main battery to chassis
main battery to Motor
aux...
X 2 with MR tyre prices especially 17" are ridiculas
16" are the go if touring the Outback,285's would
be the size most would pick , and very affordable lol
Hope this helps.
http://www.nissanpatrol.com.au/forums/attachment.php?attachmentid=65811&stc=1
To check if its exhaust manifold related just take a rag and partially block the exhaust while its idling. If there's a leak in the system it will squeal again.
That's how I finally found where the...
Don't muck about with cheap filters personally I only use Donaldson filters.
Gday. I had the same issue when I used the repco equivalent filters once. Haven't used them since as I didn't think it seemed right so just stick with ryco now.