Search:

Is it on the fixed side window, will look a bit like a de mister wire running around near the edge of the glass.
Graham

There are a couple of brackets that hold wiring, I fitted a piece of aluminium flat bar between them.
I only remember blue wire for the brakes & red was the brake light signal, both connect at the...

7330273303

This is in mine, later model.
Just above traction button, had to cut out inside of the cover with a sharp chisel.

A good idea is to trim the tails of your cable ties with flush cutters, or if you don't have a set use toe nail clippers, the sharp end can cut next time you reach in. Good to see you used a butt...

Swap lamps left to right & see if the fault follows.
Do the rears, then the fronts & then the sides.
This will eliminate the bulbs.

I wouldn't have thought that some diesel in a petrol system would be too bad, add some lubrication, and some smoke.

Still a chance, battery is probably jus above water level.

A guy at work put a Redarc unit in & loved it.
He mounted it in front of the radiator on some aluminium angle near the left side. I think the mounting points were for the second fan which is not...

I assume the VDO has some electronics in it so it is a high impedance indicator, so the total resistance of the thermocouple won't make much difference.
If it was an old school pyrometer that...

Unit can't tell what surface it is baking on, I have turned the dial down a bit when not on sealed surface, also have to turn down to 1 or 2 when there is no car on the trailer & it is too light....

Resistor is usually in the air duct (for cooling) behind the glove box.

Because a diesel does not have manifold vacuum like a petrol engine it has a vacuum pump, sometimes on the back of the alternator, for the brake booster.
Graham

Paint stripper works a treat on ali parts without damaging them.

Give Little Creatures brewery a visit.

Altronics have a kit for a 3 phase converter, you would still need to get 240v to it, your efficiency would be pretty poor. When my alternator died I measured the current draw from the battery with...