Search:

It only does that partially though - hence the words "limited slip" - it's not a locker, and will only attempt to grab for a short period without traction. My meaning was I thought you have to test...

If you are going to make your own bracket just be mindful of the forces involved and amount of force when winching, and therefore the design of the structure and quality of the welding required to...

I was looking at putting a channel (or cradle) in behind my ally bar, and doubling the anchor points onto chasis. But now have steel bar to put on. Yeahhhhhhhh.

I put my control box behind the bullbar. I have a remote control so I don't have to access the box - but I can still reach under it and connect the control lead if required.

I was so sick of...

Hi Cobber,

I did this mod to mine and subsequently a couple of others and it was one of the best things I did to the old girl.

To clear up a few things...

Firstly... the TC will lock in...

Hi Boggy,
No it's not the same. I think from memory the Y60 used pin number 21 on the TCU for the lockup solenoid. You would need to check it with your manual because some other models were...

Make sure that is NOT the case otherwise when you winch in then you are overpowering the brake as well and when you winch out there will be no brake effect.

The direction of rotation for the Drum...

I just mounted a tigerz11 winch to my factory bar yesterday. Yes you are correct, you will have to rotate the gearbox so you can access the clutch lever on the winch. Dont do what I did and rotate it...

YNOT is correct , you can't "adjust" it out what you do is move the wheel on the shaft... I did mine and its easy peasy... Mine needed to go two splines after a 2 inch lift and was then spot on...
...

There is a phillips head screw on the back of the bottom spoke. The rest is clipped on.

Tony

Nissan Matic D is the correct oil and is the equivalent of Japanese Dexron II. Use of the Australian Dexron II may cause damage to the automatic transmission.

Tony

hey mate
try a place called engine protection equipment vast range of filtration for small to massive engines ill find the number tomorrow at work

Gday mate you could try one of these, they are a little expensive but work well, I have put one on my Patrol as I also dont have a lot of room
...

Hey Boggy, i note that you are in West Melbourne mate. A 2" lift is legal in Victoria without any inspection and you can legally go 2" above placard with your tyre size also.

Most insurance...

For 2 inch lift all you need is springs, shocks and steering damper. Also a good idea to get a wheel alignment afterwards to check if you need castor correction.

Most insurance companies and state...