Clicking sound when turning.

Hey All,
After the last two times of 4wdriving it appears the Patrol now has clicking when turning both left and right.
The catch is, it only happens if it's been through water or as of yesterday after I cleaned it with the high pressure hose.
Here's a little about the car:
It's a 07 TB48, has an auto locker and still has the auto hubs.
If the noise was happening all the time I'd say it was the hubs but being it's not doing it when it's dry (the following day) I'm rather confused.

Have any of you come across this before? Any ideas?

Thank you
Mick

It's not the spring moving a bit?

My front right coil makes a slight sound very clicky kind of sound and is definitely less prominent when dry.


Sent from my iPhone using Tapatalk

Had a bump noise which increased when wet and finally found that the body mounts were worn.

It feels like it's in the steering but I'll check out both of the above. Cheers

Check the wheel bearings while you're at it.

First Id change the hubs to manual locking not auto locking

Quote:

---

Originally Posted by threedogs

First Id change the hubs to manual locking not auto locking

---

Yep. Five minute job to do. Best mod for the auto hubs.

Quote:

---

Originally Posted by threedogs

First Id change the hubs to manual locking not auto locking

---

Could this be the problem when wet and not if dry?
Or just something to do?

just do it as you have to traction systems fighting each other

Quote:

---

Originally Posted by Skitzyrex

Could this be the problem when wet and not if dry?
Or just something to do?

---

A lot of people experience clicking noises or front end noises when using auto hubs and a lokka. Personally I would never trust an auto locking hub when doing any sort of hill climb. Last thing I'd want is for the hub to disengage itself half way up a snotty climb. It may never happen but that just a risk I dont want to take. It take five minutes a side to remove the auto plate. So this just means the "auto" selection on the hub would now be "unlock".

Quote:

---

Originally Posted by mudski

A lot of people experience clicking noises or front end noises when using auto hubs and a lokka. Personally I would never trust an auto locking hub when doing any sort of hill climb. Last thing I'd want is for the hub to disengage itself half way up a snotty climb. It may never happen but that just a risk I dont want to take. It take five minutes a side to remove the auto plate. So this just means the "auto" selection on the hub would now be "unlock".

---

All too true, Cobber assuming the driver is too lazy to lock the "auto" hubs like they should do before attempting a snotty climb. Makes for lots of Utube vids if nothing else.

If they have followed the vehicle manual and/or engaged their brain they will have locked the hubs anyway (moved from Auto to Lock) sama sama as if they were 'converted' auto hubs so no real difference.

An 'auto to manual' conversion only forces the Driver to get off his jacksie and lock the hubs

Unfortunately laziness will always overcome technology and outwit brain power... this I know from years of personal experience (sigh)

Thanks guys, I already lock my hubs to lock anyway when airing down so difference to this lazy jack arse. Haha