Hi. I'm going to block the egr and remove the butterfly at the inter cooler. Can someone show me the place to block please? Thanks in advance.
Printable View
Hi. I'm going to block the egr and remove the butterfly at the inter cooler. Can someone show me the place to block please? Thanks in advance.
what is the purpose of doing this ?
Most block at the top of the EGR pipe just under the engine cover on LHS
looking over bullbar, you only need to remove bolts and slip blocking plate in position.
What motor is this happening to
Sorry. Forget that bit. TD42TI.Quote:
Originally Posted by threedogs
Here ya bud.Quote:
Originally Posted by GU_Mick
Attachment 36547
Thanks mateQuote:
Originally Posted by mudski
I have a TD42Ti as well and have been told that you should block the EGR off. What is the advantage in this and are there any trade offs or disadvantages? its for pollution control, right?
What the EGR does is allow some spent exhaust gas back into the intake manifold and then into the engine. You ever seen the inside of your exhaust pipe? Kind of black, slightly oily and sooted up. Well this is what happens to you intake manifold and over time it clogs up your intake manifold. Think of it like, cholesterol. The inside size of the the air intake gradually gets smaller. Not only this but your engine is not sucking in clean air. So your engine won't go as good as it should. Not too mention the detrimental affect this has on the life of your engine.Quote:
Originally Posted by viking
This mod is illegal though. The reasoning for the EGR is just for environmental purposes. No advantage at all for your engine.
Here is two pictures of what happens to your intake when you DONT block the EGR.
Attachment 37095Attachment 37096
If you do it I would advise on remove the entire intake manifold and giving it a good clean out.
Thanks for that, I am hearing you. I will attend to that straight away. Of course I would never do anything illegal or bad for the environment 'wink'
Check this post go to post 169 for a photographic step by step for the 4.2, I used a blanking plate from the Ferret.
Is there something similar for the removal of the intake manifold?Quote:
Originally Posted by TimE
Just pull everything apart mick until the manifold comes off. Lol. I don't think there would be much to it. Just time consuming. I need to do my engine but need the time more than anything.Quote:
Originally Posted by GU_Mick