Help me weld pleeeeessssssssseeee

I've borrowed a mig from Geeza (my toymota drivin mate some of you met at loveday) He was a panel beater in the UK. He bought his welder out with him and tells me its a beauty (i would have NFI but he is a pedantic fussy so n so) Now it hasnt been used for 16 years but all the functions seem operable. Except i cant get it to bloody weld properly. Ive done a bit of welding in the past so am not a total moron when it comes to the art, but ive never had to set one up from scratch. Geezas away so cant get him to help. Ive adjusted amperage wire speed gas flow and nothing bloody works its doin my head in. I wanna weld patches into my Torana where ive cut the rust out but am getting frock all penetration. Am getting blobs of sh!t Pics below are the welder and what the weld looks like that im getting
http://i1189.photobucket.com/albums/...792F275F54.jpg
http://i1189.photobucket.com/albums/...7941B04F5E.jpg
http://i1189.photobucket.com/albums/...79541ED728.jpg
http://i1189.photobucket.com/albums/...79618EF0E2.jpg

So any help for wire speed, amperage setting, gas flow will be great cheers.

Sorry mate I've got gasless and still learning myself but was the surface clean ? Have you looked under the lid where the wire is there may be a guide

Edit.. Pic is of under my lid , sorry ipad took it sideways

Gas should run at 10 to 15 Lpm
Big dial near gun picture is on zero turn it up to 1 or 2 doing thin gauge steel turning it up gives more heat more penetration. Then adjust the wire speed till you get that bacon crackle sound that's the one under the green light.
If the ark is really high up ans melting into the tip you need more wire speed or turn heat down if its shooting wire into the job and pushing you away slow your wire down or give more heat on te dial

To test your gas pull trigger then adjust gas while holding te trigger down

Mmmmm i'll have a look
I sanded the test piece back to metal to make sure i was getting a good earth

Quote:

---

Originally Posted by macca86

Gas should run at 10 to 15 Lpm
Big dial near gun picture is on zero turn it up to 1 or 2 doing thin gauge steel turning it up gives more heat more penetration. Then adjust the wire speed till you get that bacon crackle sound that's the one under the green light.
If the ark is really high up ans melting into the tip you need more wire speed or turn heat down if its shooting wire into the job and pushing you away slow your wire down or give more heat on te dial

---

Id turned it off and spat the dummy when i took these pics :) so when i set the gas lpm is that at rest or while its running

Just read your next post, cool i'll have a crack

While the trigger is on like you would be welding it should run say 12 Lpm inside no wind.

Good luck mate post some pics of the finish when your done if its ugly i touch it up with a sanding disk ...almost every weld i do gets touched up lol

Spot weld function should be on zero if you are doing continuous welds.