It is always a good idea to post up an introduction before asking for anything mate, gets everyone on side.
Printable View
It is always a good idea to post up an introduction before asking for anything mate, gets everyone on side.
where are you located? 12V? I have entire SD33 engine 24V setup, was reconditioned a few years back, did just over 30,000km, and is now sitting on a pallet in the shed. came out of 1981 MQ 4speed.Quote:
Originally Posted by Raydar PC
firstly sorry i forget the introduction I am just a newby to this .... any just bought my first patrol need to fix a few things before rwc and rego
cheers and once again sorry to everyone on here
I am in queensland and it is a 12v and how much for your sd33Quote:
Originally Posted by GQRD28T
Not a problem mate, it's all goodQuote:
Originally Posted by Raydar PC
Hey Plas i'm good for a bit of a spit mate but not sure that will do the job. I have been known to lay a reasonable weld that has stood the test of time but i aint no Boiler Maker mate. If i can help just yell out bud.
I have been wanting to buy one hehehehe
I would likely be able to borrow my father inlaws for a day mate he has a 200amp Mig that i did my rear bar and roof lights with. Sure he would not mind?? I think? lol
I agree, see if you cant find a Pro, if not then between the two of us we must be able to get it done. We aint no Dills.
****No smart comments from the rest a ya. :p
any one got contacts to supply and fit turbo in SA, Adelaide, thanx Barry
Hi mate, I haven't got any contacts over there but if you are considering doing this yourself then have a read of this below...
http://www.nissanpatrol.com.au/forum...-to-a-N-A-TD42