Here is a site with full measurement conversion for scales pins and screws
http://mdmetric.com/tech/cvtcht.htm
And a site for pins, rivets and mosaic pins
http://www.knifeblanksaustralia.com/...1029445?page=1
Printable View
Here is a site with full measurement conversion for scales pins and screws
http://mdmetric.com/tech/cvtcht.htm
And a site for pins, rivets and mosaic pins
http://www.knifeblanksaustralia.com/...1029445?page=1
whOOps, had to do it, just scored this badboy :oops::smileyvault-cute-bi
Attachment 39921
How thick is that thing..Quote:
Originally Posted by oncedisturbed
4.6mm across the back of the spine at it's widest
That's a biggin
Oh yeah :) going to look at maybe using jarrah scales and use rivet screws to fasten them with a countersink bit
Nice blank, here's an idea for the handle,
Now you'll need to make a sheath for it
http://www.ebay.com/itm/281087598821...84.m1423.l2648
Have all the brass cut ,now need to shape it a bit better before putting it on , as it will generate too much heat.
I have small brass rod that will be perfect ,middle pin is a bit of a worry
I have HEAPS of Jarrah if you need any... bench saw and thicknesser too to dress if you need to.Quote:
Originally Posted by oncedisturbed
these are the clamps I use plus I have some small 2" vices that help as well.
As you can see I have an edge on it now.
@OD that's a lot of width for a 5.5in blade
Nice clamps, need to get something like that as well, already 2 small vices.
With it's size, should be nice and sturdy.