What did you buy today

Quote:

---

Originally Posted by MB

Awesome Mark, you’ll love it mate, well done!
Do consider bracing the HM together too even with a standard width drum, they are a beast of a motor them Iskra Mahle’s and pull like a freight train with a shipload of amps.
Matty may know a bloke available and or Phil at The 4WD Shed that Darren kindly put me in touch with did a ripper job, powder coated black too seems to take your eye off front end grill modifications etc...[emoji106][emoji106]


Sent from my iPhone using Tapatalk

---

Already has the bracing done mate. Mal at S.G Leslie & sons done the lot. Braced it, smaller hub on the drum, shampfered the drum end plates so they dont cut into the rope, done the bearing mod to the drum and end plate, fill and drain holes. To only thin that wasn't done was a breather port. Which I can do.
Then, once this is all back together i need to shoe horn this into my bar somehow. I'll get the bar sandblasted and powdercoated after all this, she's looking a bit second hand.

Quote:

---

Originally Posted by Rossco

Very nice Markie, time to sink the old girl and test it out lol. . .

Sent from my SM-G930F using Tapatalk

---

Yeah, nup! I've learnt my, expensive lesson with bog holes.

Couple of recovery ger items arrived today, 2 x equaliser strap and a rope slide sheeve block.
Attachment 80653Attachment 80654

Nice ^^^^ Phil. I'm still chasing one of those alloy rings.

Quote:

---

Originally Posted by 10G

Nice ^^^^ Phil. I'm still chasing one of those alloy rings.

---

Check them out on ebay, GEORGE is the brand, beautifully made. About $100 I think, cant remember

New project in the works

Attachment 80688

I had been wanting to buy an Ozpig for a while now and saw they have just released a combo special with their smoker oven, so went to the local dealer and placed an order.
At least with all the restrictions in place I will have plenty of time at home to get the hang of it before using it on a trip.
https://order.ozpig.com.au/ozpig-smoker-combo

Sent from my SM-G960F using Tapatalk

Picked this 12v soft-road beauty up today in readiness for tucker farken a small select clean install crew officially allowed onsite by the gruberment [emoji106][emoji106]
http://www.nissanpatrol.com.au/forum...2020/04/17.jpg



Sent from my iPhone using Tapatalk

Raced out and bought one of these rippers today, local plumbers on site warned against a statewide NSW blitz on utes without ‘fully’ covered loads.
http://www.nissanpatrol.com.au/forum...020/05/155.jpg
http://www.nissanpatrol.com.au/forum...020/05/156.jpg
$250 but really good quality material and under half the price it seems of the fines some poor blokes around here have been coping lately apparently even with their occy/cargo non-compliant now ones.
A young bloke apparently also got smashed for a pair of muddy footy boots after training sitting back there on his tray front :-(



Sent from my iPhone using Tapatalk

We use the exact same net at work on our Transit with a 5m tray, that one was $1000 but it has saved us sooooooo much time! We permanently leave it on, and use it to strap stuff down too so we no longer use straps either.

Sent from my SM-G960F using Tapatalk