Did you get some pics for us..Quote:
Originally Posted by MEGOMONSTER
Printable View
Did you get some pics for us..Quote:
Originally Posted by MEGOMONSTER
Got a 2G power cable from under the bonnet to the cargo barrier for the dual battery system. Now I need to buy a crimping tool...
Removed auto tranny from my GQ prior to DIY rebuild (http://www.nissanpatrol.com.au/forum...sis-and-Repair)...
Yo flow if you are using big lugs flatten with hammer then use a centre punch then solder them apply heat shink and your done
Wired in an air horn installed red LED dash lights. Took her out for a little mud!
@threedogs: not sure what you mean...
Changed gearbox oil, messy job!
If you're using big allloy lugs for thick wire, after you bare the wire push it into lug and squash with vice or hit with hammer/ Then use centre pop on lug to make tighter, then heat and solder wire to lug. Apply some heat shrink and will end up with nice neat and strong join on the lug
Wish everyone would edit their profile so we know where your from
Dried out the left over wet sand in the back doors and sprayed with fish oil to stop any rust, also ct18'd the engine bay and then sprayed the hoses and all rubber with foam tyre shine, transformed that muddy dirty engine bay to a new look, next job get under her with the wire brush and get into the rusty bits underneath and then try out the hammerite rust converter paint to see if it's as good as they say.