Gu cruise control

Quote:

---

Originally Posted by Dannyboyz

Just an update for anyone who is interested, on the control box for the AP60 there is a small loop of black wire with both ends running into the box, in the instructions it says that when using the magnets, if the speed that the CC engaged at is below 40kph, to either reduce the number of magnets or cut the black loop wire. As I'm trying to use the speed sensor and my cruise would only engage up as far as 45kph, so I cut the wire, now it has a max set speed of 94kph (GPS) however if I hold the set/acc button it will accelerate up to around 110kph then cut out. So I'm sure I can make it work up to 100 but I will have to ring Command and see if there is any further calibration that can be done on my end.
If you are interested, check back for an update some time tomorrow avo

By the way, it sits on 94 like a dream, cruise holds it steady as a rock

---

Well that's sorta a win..
Bit of a bugger..
Hopefully some calibration can be done?

Let's hope so, if not, I'll just think of the fuel I will save doing 94kph all the way through central Australia!

Quote:

---

Originally Posted by Dannyboyz

Let's hope so, if not, I'll just think of the fuel I will save doing 94kph all the way through central Australia!

---

Put on 35's.. then you'll be doing 106 ish..

Ha ha, already rolling on 35s mate, maybe 37s? That could be the problem, with the GPS saying 94 the speedo is saying 102, I need my speedo to read 108 to be doing 100

Make sure you are on straight & level ground for a KM before using the GPS reading. Anything else is biased results.

Ok mate, I used it the whole way home from work last night, about 20ks with a couple of small hills up and down, after every hill it would settle back to 94

Think of the fuel..
Think of the fuel..
Lol

That's it mate! 👍

Best bit of kit out there for an auto Patrol I reckon.
had a CC in a RR we went to Cape York in,, this was back
in 83 that had magnets on the tail shaft with no problems

Ok sorry guys, phone had a nasty accident yesterday so couldnt get in for the update, official word from Command is I will have to put magnets on. Pulse is too fast out of my factory speed sensor

Sent from my SM-G900I using Tapatalk