I've got mine on 2 mins
Printable View
I've got mine on 2 mins
same here. 1 minute is standard setting on mine.
If you where running 400 -500 horsepower and running longdistance
you most likely would need a timer,you dont need one in a patrol just to run up the road to work
or the shops ,as td stated its a wank job,you know where your work is ,you know where the shops are and you know when looking for a camp spot you just back off before you get there,these modern diesels dont need much of a warm up
and dont need to idle down to much other wise you do more damage by letting them sit to long
Thanks all, I won't be fitting a turbo timer. And as long as the motor remains factory standard I don't see a lot of need to fit a pyrometer either. It's rare for the truck to get used 'hard' so I reckon just leave it as is.
Cuppa
I wrote this elsewhere on the same topic:
IIRC, at idle a turbo is still doing 15,000rpm on a diesel (ballpark figure), so even if you let your EGTs drop to the lowest they can get to before shutting off, your turbo shaft will then need to shed the heat generated by spinning at 15k, and that heat will be dissipated into the turbo housing... where the oil lines are...
The theory behind the timer is to run the engine at idle for long enough that the exhaust temp comes down, which in turn allows the impeller housing to cool down before oil flow through it is shut off. If it's left hot the oil can burn inside the galleries (known as 'coking'), and over time this will impede oil flow to the impeller shaft bearings, with predictable results.
I can't see how EGT can be used as a threshold for safe turbo shut-down; gas cools far more quickly than metal or water. So 200 on your EGT gauge at shut-down is not reflective of the heat retained in the turbo housing, not even close. The probe in the manifold housing doesn't read temp from the coupling; it reads temp from the tip of the probe.
It's probable that modern materials, engineering tolerances and oil compositions make idling down the temp largely unnecessary, but I am certainly not taking chances... I run my timer at 30 seconds and almost always let it run out (unless I've just arrived home as the last minute or so of the drive is very low rpm and mostly downhill). When I go wheeling or up the beach I bump it to 3 or 5 minutes.
I have my 'turbo timer' running off my EGT gauge. It is set to shut down at 140deg pre-turbo. While I know what your saying Squalo I still think EGT has to be a more accurate way of allowing the turbo to cool down. I have found that if I go to the shops and take it easy while looking for a car park, it does not need to idle. But I live 100m from a 100kph road so I can't just take it easy for the last couple if mins and I mostly have exhaust temps of over 200 deg when i turn my car off so the car will run down for up to 5 mins.
And Cuppa, you might be quite unpleasantly surprised with how high EGTs can get on a factory tune, especially on a DI ZD30 . A pyro is pretty cheap insurance if you ask me.