Just swapped out all my sway bar links with ones that are now the right length for the lift.
Stupid previous owner only doing half a dam job.
Heaps better looking then the old ones.
http://i1222.photobucket.com/albums/...103_120430.jpg
Printable View
Just swapped out all my sway bar links with ones that are now the right length for the lift.
Stupid previous owner only doing half a dam job.
Heaps better looking then the old ones.
http://i1222.photobucket.com/albums/...103_120430.jpg
Took it out for a play with my mate Fry teaching how to 4wd and all my other bad habitsAttachment 36318Attachment 36319thats Fry's new bus
My old girlAttachment 36320
I've never understood why they make the thread so long for the ball link.. It's only 30mm deep?? LolQuote:
Originally Posted by Shaun 4x4
But they look better than the original.
The kit said for 2-8" lift. I had to cut about 40mm of the thread of the get it to line up properly.
Oh and I installed some full size weather shields.
Not quite as dark as I'd hoped when I ordered them so might have to get out the night shade
Ow ok, thus the long thread..Quote:
Originally Posted by Shaun 4x4
had to cut off the side steps with an angle grinder, they really have taken a battering in the last 3 years. All the bolts were bent, brackets also folded over so cant undo some of the bolts, most of the weld has come undone........... totally fubarred is the word. Will have to get the Q up on a hoist or something so I can get underneath properly and remove the rest of the bracketry.
Had to cut mine with a gas axe when I did the clutch as it was all rusted and the thread was completely knackered
totally transforms the look of the Q hey, makes it look a good couple of inches tallerQuote:
Originally Posted by 93patrol
Then take the bullbar off and it makes it look even higher. See my avatar lolQuote:
Originally Posted by Clunk