Good stuff pacs, you'll see a big difference in economy
FanTapstic!
Printable View
Good stuff pacs, you'll see a big difference in economy
FanTapstic!
Does anyone have a picture of the mod to the shaft needed for pertronix ignition 2 before and after the grind I haven't pulled my distributer apart yet cause the car is my daily work horse and I can't afford to stuff up so if someone is able to post a pic it would be great thanks
I ground my dizzy today. I pulled the dizzy apart, and found I could pull the shaft off. I just span the shaft and ground it done using my bench grinder. (took about 30 seconds)
The bit you need to ground is the stopped for the rotar button. I had to take a mm of the supplied spacer as I could not do up the screw that retains the rotar button.
I went out to the melb supplier of the pertonix,as m,t ls version had a suspect fault - they refunded the money and I brought the magnetic sensor and a flame thower. THEY ARE GREAT TO DEAL WITH
Does anyone know what the two blue wires are that are attached to the coil through one ring terminal
What terminal are they going to.
Heyy man im having problems with mine it wont start did yours do this?