Patrol..

On your lift. by the receipt I have from when the OME 2inch lift was installed it says...

• front left pre fitment : 750mm
• front right pre fitement : 755mm
• rear left pre fitment : 785mm
• rear right pre fitment 779mm
• front left post fitment 804mm
• front right post fitment 807mm
• rear left post fitment 843mm
• rear right post fitment 843mm

all measurements taken from bottom of guard to lower section of the rim. 16inch rim too.

Few pics from the weekend. My mates GQ makes mine look like it isnt lifted

You can figure out the lift by measuring the bump stop heights.
I think the superior website has all the stock heights. just measure yours and compare.
Nice truck mate :)

I got some dims off a spec sheet but can't find the link. Stock height at time of compliance for series 1-3 is as follows.
Measurement from centre of wheel to underside of mudguard lip.
Front 555mm
Rear 560mm

I found it easier to work this back to a top of wheel dimension for measuring purposes.

My first patrol sagged more than an inch after a few months but I had quite a lot of accessories so don't expect a 3" lift to be 3" if you have a heavy 4x4 especially if it's a td42???