Originally Posted by
PMC
G'day trendsetters,
On a serious note, if we are going to spend between $3000 and $4000 for a motor for Roofy, then i think we need to discount a secondhand engine.
I have located the following motor listed below is situated in Clayton South Victoria, it is a fully reconditioned engine with 12 months warranty, the mob wants $4600 exchange. I think we could contact these folks they might come to the party and let us have the motor for around $3500 or $4000. Plus the motor also comes with a brand new head and 12 months warranty. The blokes business number is 0400 033 377. I think you folks need to contact this chap ASAP to see what deal the bloke might offer.
Hi there, Up for sale I have aFully Reconditioned ZD30 Engine for sale on exchange basis. Happy to let youpickup / post this engine prior to handing over me your existing faulty engine if you are happy to pay an additional $700 core deposit (fully refundable once I receive your old/faulty engine)
This engine is only suited for standard diesel engines and is not suited for commonrail injection system.
Please read through the listing carefully to see all the added extras that’s on offer with this engine, as most of the extras are only offered by us!
This engine comes with a Brand New Head not a previously cracked / welded head!!
This engine has been completely stripped, all parts hydrowashed.
Cylinders are individually bored to manufacturers specifications than diamond honed & plateu finished (highest quality finish available on the market).
Cylinder head contact surface / Deck has been surfaced(milled)
Conrods checked for twist & straightness
Cam shaft as well as the balance shafts checked for cracks, straightness than linished
Crank shaft checked for straightness & cracks, journals measured than compared to factories allowed measurements, if its within specks linished, if not; journals are ground to factory specs using Schou CrankshaftGrinder
After the machining of all parts they were washed again prior to assembly
Brand New Cylinder Head was assembled with reconditioned valves, springs, caps, collets and buckets, valve clearances set to manufacturer’s specifications using brand new shims.
Oil cooler has been pulled apart, hydro washed, all gaskets and seals replaced during assembly and vacuum tested prior to fitment.
This engine was assembled using all of the following brand new components:
Cylinder head
Pistons, Pin’s and Rings
Main bearings
Bigend bearings
Timing Chain & Timing Chain Tensioner
Complete Gasket Set
Head Bolts
Water Pump
Rear Main seal
Glow Plugs
Injector Seals
Glow Plug Seals
This engine comes with 12 months / unlimited km's warranty
Please note this engine is also available on our shop floor as well as other market places, so it may be sold prior to your purchase / end of this listing. To confirm availability please contact me and I will let you know the availibility.
Item islocated in Clayton South Victoria, I'm happy to freight these engines atadditional cost Australiawide! Any Questions or simply call me on 0400 033 377.
