Looks like you have a flat surface around the bolts, the support for my bull bar is an L shaped bracket with the rear of this preventing the mounting of the recovery point.
Printable View
Looks like you have a flat surface around the bolts, the support for my bull bar is an L shaped bracket with the rear of this preventing the mounting of the recovery point.
On the alternate point, i think the radiator guard is mounted in that position so no clearance.
Try those Tee shaped ones on the outside of the chassis, see if any holes line up
What year is yours again please
Drivers side
Attachment 23081
Attachment 23082
Attachment 23083
Weird but looks like the series one plate will fit. It replaces that loop held on by 3 bolts, you'll just have 3 holes on the LHS with no nuts, Sure that wont fit to outside of chassis
Im not sure i understand...
Attachment 23084
Does this pic help?
http://i156.photobucket.com/albums/t...2-05094103.png
Thanks Rip, I also have a limited number of rear seat cover plates to suit the GU. They just tidy up the back a bit after you remove the seats.
Thanks Rip, Looks like the bull bar mounts are quiet different to what i have. Im working on a solution though.
You'll eventually get it , I can fit all 3 different styles to my TJM bar, go figure