-
1 Attachment(s)
Mudski has 30 psi mine has 26 psi basically you need 10psi at 100 ks on a flat hwy
then use your needle valve to adjust the spool up rate, .
Normally at idle with the NV closed you slowly open it till the atuator arm falls away on the turbo at that point nip up the NV.
BTW where have you put the EGT bung most have it 150mm post turbo
Std boost is about 15 psi but if you can squeeze abit more without doing any harm why not, again its only a three litre
Btw I think my temps are higher than normal as the egt bung is very close to the turbo
you can just see the bung in this pic way too close imo
-
Cheers 3 dogs... I don't know what's going on with mine but I can see upto 25psi.. That's with standard setup... No Dawes/needle valve installed... My pyro bung would be arnd 100-150mm back frm turbo... Looking at investing in a electronic boost controller in the near future so I can run a standard boost setting and a higher 30psi setting once I have enough funds for snorkel and exhaust upgrade...
-
Check out Chaz Yellowfoots dual dawes set up Dr Gary just finished his install.
I might change the position of my bung if it doesnt cost an arm and a leg.
I always thought it was 150 down the dump pipe doh
-
4 Attachment(s)
Finished wiring up my lights on the roof...
Fuses and relay nicey tucked away inside frnt kickpanel.. couple pics of how i ran the wiring...
-
I like the way you ran that wire to the roof might have to copy it
-
I didnt need any clips or anything... 4mm twin core tucked into that seem outside the windscreen perfecrly...relay and fuses behind drivers side kick panel away frm engine bay temps and possible water and easy as too acess...
-
1 Attachment(s)
I put my roof light switch here,plenty of room behind for more as well
-
Plan on running my dual battery gauge in that spot...like you said a lot of room there..
-
Yeah thats my aux batt guage there, the main is in front of the instrument cluster.
My 12v clock arrived today 52mm but having trouble figuring out where to put it lol
Also have a small 12v rectangle one, might fit under the batt gauge, not sure ATS
Got another head unit coming the only thing left working
is music on SD card and the TV on this one GGRRRrrrrrr
-
can anyone advise me on how i go about trying to get a couple of the forum stickers for my bus? cheers and thanks in advance..
