Black rims

Quote:

---

Originally Posted by Winnie

You are taking 10mm from one side and adding it to the other.... sorta hard to explain with words.

---

Quote:

---

Originally Posted by MudRunnerTD

The measurement should to the same face of the rim. From the front you have to measure through the centre hole to the mounting face.

---

Quote:

---

Originally Posted by benno77gu

did that ended up with 20mm difference

---

Winnie is on the money mate. If you are 20mm out then 10mm of that belongs on each side of dead centre ;).

If you consider that as George said centre was 100mm then you have a 90mm on the front and a 110mm from the back. This is positive 10mm. 10mm from centre.

Hope that helps

Mind you a rims width is measured from the inside of the bead, as i was told when i got my FR Simmons hand built....

Hey guys, can you tell me if these are the right spec for a 08 GU Patrol?

http://www.summitracing.com/parts/pc...6883/overview/

I don't have the best reception ATM but if they are PCD 6/139.7 center bore 110.5mm and an offset between -13 to +10 your in!

All good except the centre bore!! Its only 80.77mm!!

Edit - Oh and offset is only -12.

The Offset would be fine but the centre bore would be No Good. You could get them machined on arrival if the bolt pattern was right though??

PCD is fine 5.50" = 139.7mm but yeh the center bore is no good

Bummer, really like the look of em hey.

Has anyone coated standard GU alloys (latest shape rim) just wondering what they would look like black?

Quote:

---

Originally Posted by bowerbird

Has anyone coated standard GU alloys (latest shape rim) just wondering what they would look like black?

---

Look good powder coated.



Attachment 55221

Sent from my S4 using Forum Runner