our car

Quote:

---

Originally Posted by healy

The hole in the pic are they a rated point for recovery/double line pulls etc 90% sure its a tjm bar

---

I would not.

Quote:

---

Originally Posted by MudRunnerTD

I would not.

---

Thats what I was thinking cheers

good work mate, good to see things are going your way and congrats with the bub too mate.

Quote:

---

Originally Posted by healy

Ill have to change that pic and hide it I must admit I lost a lot of enthusiasm about 4wding with that thing. The hole in the pic are they a rated point for recovery/double line pulls etc 90% sure its a tjm bar

---

Might be an ARB bar. Definitely not a place for a shackle, that loop is designed to be used with one of these, and a high-lift jack. I see sooo many people snatching using those... they must be tough because I don't know of a failure yet, but the point is that it is NOT designed for recovery loads.

You need to put proper recovery point/s on the chassis horns.

https://www.expeditionexchange.com/r...r/DSC01387.jpg

I got my bar modified to strengthen it up for a winch and at the same time welded 5mm plate next to those eyelets to thicken them up. The plates go back to the chassis mounting points. Tough as now.

Quote:

---

Originally Posted by healy

The new wheels has arrived

---

Looks pretty neat ... not too many look like that by now

Lets hope it is a good one for you - either way you can't really lose on this one for the price.

Mic

Looking good Healy, did you end up stripping the other car or sold it whole?

Well done mate. Looks clean as..
Now those holes in the front if the bar. They are an intended winch point. Those points run inline with the chassis points..
I would feel safe using them if winching a double line or bridle Off them, but not snatch.

Anyway mate. To celebrate it, I'd like to offer a swap.. And before you say no, to late, Its done..
Sell the gu light mount and Im doing you up a stainless gq one. I just need the bolt centers again for the bar..

Lets start this bus with some bling..

Quote:

---

Originally Posted by trekster

Looking good Healy, did you end up stripping the other car or sold it whole?

---

Parting it out to pay for the parts needed for this like to get a rear bar and snorkel dosnt have a snorkel yet

Quote:

---

Originally Posted by Westy's Accessories

Well done mate. Looks clean as..
Now those holes in the front if the bar. They are an intended winch point. Those points run inline with the chassis points..
I would feel safe using them if winching a double line or bridle Off them, but not snatch.

Anyway mate. To celebrate it, I'd like to offer a swap.. And before you say no, to late, Its done..
Sell the gu light mount and Im doing you up a stainless gq one. I just need the bolt centers again for the bar..

Lets start this bus with some bling..

---

I was just gonna fit it up this one should be fine