Winnie's Warn hi mount rebuild

Quote:

---

Originally Posted by MudRunnerTD

It was $24.95 mate. That's nt what I need anyways. You don't need them either AB, you just need a couple of longer bolts.

I need 1 or 2 of the square nuts used to hold the top hat on. Hey Winnie you haven't got any in that box of your have you?

---

Hmm, I'm not sure Daz, I'll check in the morning and if I do then I'll bring them up to Licola for you

Quote:

---

Originally Posted by MudRunnerTD

It was $24.95 mate. That's nt what I need anyways. You don't need them either AB, you just need a couple of longer bolts. I need 1 or 2 of the square nuts used to hold the top hat on. Hey Winnie you haven't got any in that box of your have you?

---

I know mate but they say RRP $45.

Quote:

---

Originally Posted by AB

I know mate but they say RRP $45.

---

Oh it's for a Himount winch..... We can charge Drug Money!!!

Only $2.50 more than low mount.

Umm go to the bolt shop? Any decent bolt shop should carry these.

Quote:

---

Originally Posted by nissannewby

Umm go to the bolt shop? Any decent bolt shop should carry these.

---

Even the square nuts Matt?

Quote:

---

Originally Posted by MudRunnerTD

You can fit your filler to the side if you like. Plenty of room. You would have to use a syringe to fill it though? Do it to the front quarter of the casing. Alternatively you could drill and tap big enough for a filler on the side then instead of a plug bolt use a male/female reducer and fit a pnuematic fitting and your breather in the same hole.

---

So do you mean that when you unscrew your breather then that becomes your fill hole?

Quote:

---

Originally Posted by Winnie

So do you mean that when you unscrew your breather then that becomes your fill hole?

---

Yes mate. But the air line fitting I used for my breather is too small so fitting that fitting into a reducer so it can thread into a bigger hole would work fine mate.

So say you have a 1/2" hole tapped" fit a 1/2" to 1/4" reducing socket then fit a 1/4" air line. When you want to fill it just take out the 1/2" socket

Quote:

---

Originally Posted by MudRunnerTD

Yes mate. But the air line fitting I used for my breather is too small so fitting that fitting into a reducer so it can thread into a bigger hole would work fine mate.

So say you have a 1/2" hole tapped" fit a 1/2" to 1/4" reducing socket then fit a 1/4" air line. When you want to fill it just take out the 1/2" socket

---

Yeah cool, thanks I might play around with something

Quote:

---

Originally Posted by MudRunnerTD

Even the square nuts Matt?

---

Yeah the square nuts they should. Is there something special about the bolts?