GU IV Subtank switch relocation = NO COST
The remote head for my GME 3520 is mounted below the heater controls, the main body of the radio is mounted under the passengers seat. The remote head was in the way of the subtank switch (which was always a pain to get at anyway).
So I moved the Radio aerial up/down switch back one spot and moved the subtank switch to where that switch was. I did this because the wiring loom for the subtank switch would reach this spot without stretching, and the aerial switch had plenty of excess cable.
For those that haven't pulled out their console there are two screws either side of the front of the console and one below the ash tray. Pull out the console (Screw off gear nobs first) and you will see two screws holding in the panel where the subtank switch is mounted, undo and pull forward and down, two clips on top edge will come out easily. You can now get at the subtank switch and cable easily.
http://i8.photobucket.com/albums/a44...u/DSC04914.jpg
http://i8.photobucket.com/albums/a44...u/DSC04915.jpg
The switch blank from the console goes back into the subtank "hole".
I also moved my driving light switch up to the blank spot beside the instrument lights dimmer switch, to pop the panel required levering on the bottom and left hand edge. The switch required a bit of trimming top and bottom to fit into the indented panel.
http://i8.photobucket.com/albums/a44...u/DSC04917.jpg
All up it took me about 30 mins and cost nothing. The convenience of having the subtank switch within easy reach, and able to be seen is well worth the effort i think.
