Well today thought test out winch on new ute.
Just pulled a old Ute all on level ground.
Now got bout 1 metre from all way bck in and now stop working just makes a clicking noise.
Any ideas ?
Printable View
Well today thought test out winch on new ute.
Just pulled a old Ute all on level ground.
Now got bout 1 metre from all way bck in and now stop working just makes a clicking noise.
Any ideas ?
The clicking is the control solenoids or contacter depending on how the Winch is controlled (Warn method or Tigerz method)
Did it stop dead or just get slower and slower ?
Anyway... Check all the hi current terminals for a loose connection at the Battery, Winch and also the Control Box.
It stopped goin in but went out still now just clicks
OK, the Winch is series wound IE it uses exactly the same windings and cables to winch In or Out so if it goes one way and not the other the Motor should be fine as should the hi-current wiring.Quote:
Originally Posted by largey
I am tipping that it will use four solenoids not a contactor so two solenoids need to engage to drive one way and a seperate two to drive the other... could be wrong tho.
Anyway, sounds like a control issue. Can you open the Control Box or is it sealed. I'm not familiar with the X9 but Warn's are notorious for getting a loose connection on the Solenoids ergo you will hear the click but the winch won't run.
Well took into today ay yes was a solinoid
Bit of an update finally bit bullet got fixed today it has two solinoids which was burnt and also the neg wire was burnt
New solinoids in had to make new brackets fun.
Anyway all bck together and works beut
good to hear she's all working again. Are the new solinoids an upgrade? or just replaced with standard?
Good call Evil Twin!Quote:
Originally Posted by the evil twin