Howdy I have about 5-10mm Wobble on drivers side front when jacked up (Wheel Bearings?) :beer:
Printable View
Howdy I have about 5-10mm Wobble on drivers side front when jacked up (Wheel Bearings?) :beer:
Could be hub pivot bearings also.
With the wheel jacked up, watch the hub while you wobble the wheel and see if you can see any movement there.
If not then there's a good chance it's your wheel bearings.
Pull them out and inspect them before tightening them up as they may be worn.
Good chance to repack them too, both sides!
Cheers
Maybe but not always....... You could have a crook king pin bearing in you ball hub.
Howdy
Thanks YNOT and all if any one else is looking to do this Job or more have a look at this link:
http://www.nissanpatrol.com.au/forum...wheel+bearings
I finally got that drive gear of and both lock nuts were very lose, undone both with little effort repacked with grease and toghtned to specs and 1/2 Hour later Jobs done.
Regards
Neil
After fitting 35's my drivers side wheel bearing would work its way loose over time so I fitted GU locking system. Fixed the prob.
sometimes its good just to recheck them after a tank or two