Kaymar Dual Wheel Carrier Bearing Problem

Hi All,

So today I finally pulled down my Kaymar dual bar (one side of the swing away has been driving me nuts for a few weeks now)
The bar when opening up stopped opening up the whole way, and the bearing seal and popped out, indicating the internal bearings were stuffed.

I pulled the spare wheel off and pulled down the bar pivot point and found two sets of bearings held on by a crown nut.

As suspected, the bearings were shagged, the top disintegrated on me as i pulled the bar off, and the bottom I managed to re-assemble temporarily.

Just wondering, does anyone know where I could get a set of bearings for these? Would i have to go back directly through kaymar, or is there a supplier on here, or somewhere that I can order them from?

Any help of pointing me in the right direction would be appreciated,
Cheers,
Westie

Hmmmmm? Give them a call and ask if they are Holden or Ford bearings. Post the answer here would be great. Or take the old races into a bearing place and they will size them up no worries. Or take the old race into Supercheap and compare the size to what they sell. Should be a common size.

Measures the shaft diameter and if you can take the race carrier in.
Find a bearing shop..
I'm with MR..
Surely it'll be a holden or ford bearing..

Yeah I thought the same Westy/MR, was just hoping there was an easy off the shelf solution, (like that ever happens!)

I'll give Kaymar a buzz first tomorrow, there's something about a bearing kit on there website, so maybe that might be a solution, if not I'll give it a measure and speak to a bearing joint down in Adelaide, see what they can come up with.

Cheers Fellas,
-Westie

Is there any numbers on your bearings? If so any bearing supplier will match these straight away. Otherwise go as suggested above take the old ones in. Buying through kaymar they will be marked up like no tomorrow.

Im pretty sure they use holden stub axles for their carriers.
I've used the same for my tyre lifting hoist,,, I can get some
bearing numbers off that if required

Part numbers for both Holden and Ford in the link




http://www.ebay.com.au/itm/Trailer-B...6Uf_voDozA0Frg

Thanks Nissan/TD, There were no numbers visible on them so was unable to track them down that way, I did however get a hold of Kaymar directly today, and have to say that they were excellent!

Service by "Nicole" was great, helpful, knew what I needed and even provided the part numbers if I wanted to source them myself.

It turns out, after 2004, they changed to ford bearings, if any of you have the same issue the part numbers are:

Top Bearing - LM12749/10
Bottom Bearing - L68149/10
Seal - 402903N

I did not bother trying to beat the price, at $36 per side for the kit, for top, bottom bearing and new seal, i definitely wasn't going to squabble over the price!
(I only needed one side, but thought bugger it do both at the same time and keep the old ok one as a spare!),

Hope this helps anyone with the same problem in future :)

Cheers,
-Westie

Good the hear ,did you also buy new dust seals/caps as well

Quote:

---

Originally Posted by threedogs

Good the hear ,did you also buy new dust seals/caps as well

---

Nah, they are in perfect condition, it was just the bottom seal and the bearings that were buggered :)