Hello, replacing the injectors after having them serviced, my Ellery manual does not specify a torque figure, can anyone help.
Thanks
Burto
Printable View
Hello, replacing the injectors after having them serviced, my Ellery manual does not specify a torque figure, can anyone help.
Thanks
Burto
Hey does this help or are you already done Removal and Installation
1. Remove fuel injection tube and spill tube.
2. Remove injection nozzle assembly.
Also remove gasket from nozzle end.
3. Install injection nozzle in the reverse order of removal.
Injection nozzle to engine:
: 59 - 69 Nzm (6.0 - 7.0 kg-m, 43 - 51 ft-lb)
Injection nozzle to tube:
: 22 - 25 Nzm (2.2 - 2.5 kg-m, 16 - 18 ft-lb)
Spill tube:
: 39 - 49 Nzm (4.0 - 5.0 kg-m, 29 - 36 ft-lb)
a. Always clean the nozzle holes.
b. Always use new injection nozzle gasket.
c. Note that small washer should be installed in specified
direction.
d. Bleed air from fuel system.
Disassembly (No. 2 - 4 nozzles)
Do not disassemble No. 1 nozzle (with needle lift sensor).
1. Loosen nozzle nut while preventing nozzle top from turning.
2. Arrange all disassembled parts in the order shown at left.
SEF939S
Nozzle side
Combustion
chamber side
SEF662V
SEF669A
SEF670A
Holder
Adjusting shim
Nozzle spring
Push rod
Distance piece
Nozzle nut
Nozzle body
Nozzle needle
INJECTION NOZZLE
EC-
Thanks mate, have removed injectors, fitting new ones with reco motor, your reply was most helpful,
Burto
No Probs if you give me your email I,ll try sending you the entire work shop manual if you want.
Hi mate,Quote:
Originally Posted by peterbr1
im currently rebuilding my zd30 crd and im stuck at a few places for torque specifications and sequences example the block retainer plate specs and sequence are able to email be the workshop manuel?