Hi all
Well it's official my Hard Case will not fit due to my caster correction plates, the top bolt is fowling it from going all the way back.
Has anyone else had this issue?
Cheers Lachy
Printable View
Hi all
Well it's official my Hard Case will not fit due to my caster correction plates, the top bolt is fowling it from going all the way back.
Has anyone else had this issue?
Cheers Lachy
get the grinder out
Start problem solving and get the thing on already.
The front of Mine hits the panhard rod but that from my radius arm spacers bringing the diff forwards. I just modified the guard with a hammer and a big one at that .
so many mods that are all important and you cant fitQuote:
Originally Posted by lachdiggitydog
the diff protector on takes less than 5minutes normly
grinder and hammer if you will
Lachy is it possible to remove the offending bolt, fit the hardcase and replace the bolt which should now be in front of and clear of the hardcase?Quote:
Originally Posted by LachDiggityDog
Or is the bolt that close to the diff?
I am a little confused why you can not get it to fit. Which bolt is it the top or bottom?
http://www.nissanpatrol.com.au/forum...5&d=1385549801
Hi Macca it's the top bolt that is fowling I haven't tried to take the bolt out yet as you need to take all the weight off it to do so even then I think it is still going to hit. Ill post some photos when I finish work. I have already cut the thread flush to the bolt as you will see in the photos I will put up.Quote:
Originally Posted by macca
Did you have a similar issue?
I don't have the plate like you. It basically pushed / wriggled past the bolt and was a neat fit that slid home around the diff really easily.
Your plates are mounted in another hole by the look of it, did you put them on? and drill another hole in the bracket on the diff
thankyou macca your help, or trying to help is a bit more usefull than just get it on already and get the grinder out!
Finally did the trip to the po box. Looks good Mal, thanks!
Ill fit up this weekend.