OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. Replies
    14
    Views
    4,948

    I've replied already on another forum, so for...

    I've replied already on another forum, so for benefit of members in here; HPD MAF housing lowers voltage about 0.25V give or take. Without increasing the fuelling via diesel chip the net effects are...
  2. Replies
    14
    Views
    4,948

    The hpd maf housing and air box lid have probably...

    The hpd maf housing and air box lid have probably dropped your maf voltage, giving you less fuel.
    You can put the old housing and air box lid on and check the maf voltage at different revs, and...
  3. Replies
    3
    Views
    1,207

    G'day Booshie, a generalism I've found holds up...

    G'day Booshie,
    a generalism I've found holds up pretty well is, if all is good before you fiddle and all is crap after, the fiddle may well have something to do with the new status.
    Cat converters...
  4. Replies
    17
    Views
    6,085

    I think Critta may mean 'cat', which is entirely...

    I think Critta may mean 'cat', which is entirely possible and a great excuse for a shiny new exhaust ;)

    Boosh, is your EGR blocked?
  5. Replies
    17
    Views
    6,085

    The car could have collapsed causing back...

    The car could have collapsed causing back pressure and stuffing everything up.
  6. Replies
    17
    Views
    6,085

    I think you may have your terminology mixed. ...

    I think you may have your terminology mixed. Overboost suggests (for example), if you have your dawes set at 14psi, when you accelerate you 'overboost' and hit 16/18 psi before it settles at 14. ...
  7. Replies
    20
    Views
    11,427

    UPDATE: almost there

    UPDATE: SO just about finished, still need to dress the cut edges and get some black covers for the screw caps, but other then that, done.

    What you think.
  8. Replies
    8
    Views
    4,108

    Rods shop or Beaudesert do good bolt on exhausts...

    Rods shop or Beaudesert do good bolt on exhausts at a fair price.
    Rear main seal is a no brainer , Not much you can do to a 3ltr IMO
    I would be looking for efficiency not increased power, its only...
  9. Replies
    8
    Views
    4,108

    You should pull it down to see if it ran dry from...

    You should pull it down to see if it ran dry from no oil pressure, pulling it down and finding the cause of its failure will also help you decide weather to get a low km 2nd hand long motor (...
  10. Thread: Crazy Rattle!

    by Yendor
    Replies
    6
    Views
    1,702

    When you replaced the fuel filter was there any...

    When you replaced the fuel filter was there any water or gunk in the old filter?

    As a test try unplugging the sensor from the bottom of the fuel filter and see if this turns off the light, it...
  11. Thread: Crazy Rattle!

    by mudski
    Replies
    6
    Views
    1,702

    All the injector lines up tight? As the acc pedal...

    All the injector lines up tight? As the acc pedal is electronic and it doesn't do it when your foot is on the pedal it sounds to me a fuel leakage and the rattle is the engine sucking in air from...
  12. Replies
    2
    Views
    1,216

    I use contact cleaner, just spray till it drips...

    I use contact cleaner, just spray till it drips off clear and you should be able to see its nice and clean.. Try to avoid touching the inside where the air goes.... After a good spray i blow it off...
  13. Thread: dawes valve

    by threedogs
    Replies
    7
    Views
    2,326

    PM mudski he may have some Dawes stock in, other...

    PM mudski he may have some Dawes stock in, other than that ring Dependable distributors in Sth Aust , they take your order over the phone
  14. Replies
    2
    Views
    2,566

    Hi boosh Have you checked your fuel filter for...

    Hi boosh
    Have you checked your fuel filter for leaks.
    Befor every start prime the filter using the hand pump. If car starts with no rough idle you might have an air leak into fuel system.

    Just a...
  15. Replies
    20
    Views
    15,377

    Hey Biggus, Try using heatshrink on the locking...

    Hey Biggus, Try using heatshrink on the locking bar, it lasts for ages.
Results 1 to 15 of 17
Page 1 of 2 1 2