OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Search: Search took 1.00 seconds.

  1. Thread: RLI (Paul) Update

    by jack
    Replies
    46
    Views
    10,662

    RLI (Paul) Update

    As most of you would be aware one of our more colourfull members RLI (Paul) has been missing from the forum lately. I'm sure many are missing his entertaining stories and comments - I certainly am....
  2. Replies
    9
    Views
    3,944

    Did you get a template for the location of the...

    Did you get a template for the location of the angle for the bushes? Maybe this was reversed on one side but I find it hard to beleave they could be the cause as the bushes are only about 50mm from...
  3. Replies
    9
    Views
    3,944

    Did you fit the bushes? Are they aligned...

    Did you fit the bushes? Are they aligned correctly? My thoughts were if it was a front radius bush out of alignment though it would only really affect the front corner not consistently a full side of...
  4. Replies
    9
    Views
    3,944

    Hmmmm, generally the right will sit a little...

    Hmmmm, generally the right will sit a little higher to account for the driver , spare wheel and sub tank. But 50mm is allot! Those numbers a re pretty consistent too hey! A little odd mate. I would...
  5. Replies
    9
    Views
    3,944

    Can you post a pic of the car. 50mm must look...

    Can you post a pic of the car. 50mm must look ridiculous! Are you sure you have seated the spring properly? Did it have that lean before you did the caster correction?
  6. Replies
    6
    Views
    4,164

    Yes the dash needs to come out. I think you...

    Yes the dash needs to come out.

    I think you can get away without removing the drivers side airbag, just need to undo the bolts on the steering column.

    Yes the airbags have connectors, they are...
  7. Replies
    15
    Views
    23,390

    DP Chip fitting instructions - DP34, NOT CRD MODELS

    See the attached PDF for the fitting instructions for a DP34 DP chip. Saves you having to send you chip to DP for a "reprogramme" just so it can get fitted to troll the same as what it came off. And...
  8. Replies
    15
    Views
    10,044

    Edit : See the DIY thread for instructions...

    Edit : See the DIY thread for instructions...
  9. Replies
    15
    Views
    10,044

    Just email or ring scott at DP Chip, great guy...

    Just email or ring scott at DP Chip, great guy more than willing to help you
Results 1 to 9 of 9