OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Search: Search took 1.00 seconds.

  1. Replies
    6
    Views
    7,260

    Just make sure the fuse that you replaced is the...

    Just make sure the fuse that you replaced is the right one. What on the fuse board says the tail light may not be the right one. This happens when the car goes through backyard modifications and...
  2. Replies
    6
    Views
    7,260

    So do your front park lights and dash lights...

    So do your front park lights and dash lights still come on?

    Its common for the trailer plug wiring to cause that sort of fault if its only your rear tail lights not working
  3. Replies
    6
    Views
    7,260

    Is that all of the rear lights not working. Do...

    Is that all of the rear lights not working. Do you have a trailer plug installed?
  4. Replies
    28
    Views
    8,095

    Free to good home: GQ Kingsley side steps

    I have two Kingsley step boards from my 97 GQ LWB if anyone wants them.
    Good condition. All fittings. Can't be bothered trying to sell them, they're taking up space and hopefully someone around...
  5. Replies
    0
    Views
    22,030

    Sticky: IMPORTANT! - Forum rules to sell in this section

    1 ) This section is for only selling Nissan Patrol parts and 4wd accessories. anything else advertised in this section will be deleted.

    2 ) We are not eBay, all advertisements must have a price....
  6. Replies
    16
    Views
    7,259

    Run a battery feed to both switches. Run a wire...

    Run a battery feed to both switches. Run a wire from terminal 86 of the relay and connect to both switches.

    The rest of the connections at the relay are

    Terminal 85 of the relay connect to...
  7. Replies
    16
    Views
    7,259

    X 2 on that one, you need to pick up the "cold"...

    X 2 on that one, you need to pick up the "cold" wire on the reverse switch and activate the relay with that wire, unless you are using LEDs
    Otherwise "meltdown".
    Darn, where's Yendor when ya need...
  8. Replies
    16
    Views
    7,259

    That's the fuse-poppin' way :p [Tapatalk2 on...

    That's the fuse-poppin' way :p


    [Tapatalk2 on Nexus7]
  9. Replies
    16
    Views
    7,259

    I drilled a hole in the large barn door behind...

    I drilled a hole in the large barn door behind the spare wheel carrier bracket - then pushed in a rubber gromet, pushed wire through, and applied small amount of silicon to seal it off.

    Toggle...
  10. Replies
    16
    Views
    7,259

    If you are not sure about wiring just buy a light...

    If you are not sure about wiring just buy a light relay kit.. Super cheap have them for about $28 but I prefer the proper ones for about $60.

    Power is taken form the battery but the trigger is...
  11. Replies
    16
    Views
    7,259

    Without drilling the only 2 ways I have heard of...

    Without drilling the only 2 ways I have heard of is the way you mentioned and also running 20mm pvc tubing up the front along the snorkel????

    I just got my mate a strip of that flexi led light to...
  12. Replies
    6
    Views
    3,955

    You have a raised rear springs by pedders you...

    You have a raised rear springs by pedders you might just try matching fronts to level it out.

    http://www.pedders.com.au/catalogue/
  13. Replies
    6
    Views
    3,955

    could also be softer than required springs in the...

    could also be softer than required springs in the front as per the piccie a bar and winch on the front means a higher loaded spring to compensate for the extra weight on the front of the vehicle,...
  14. Replies
    6
    Views
    3,955

    you inherited a great beast mate, it is more than...

    you inherited a great beast mate, it is more than likely the arse end sagged out & he beefed it up a little, I dont know the spec for hieghts but they are on here, if immediately concerned measure...
Results 1 to 14 of 14