Search:

Here is a link to the manual.
http://www.uniden.com.au/RESOURCES_MAIN/pdfs/UH7760NB_OM.pdf

Check that you haven't accidently changed the Auto Squelch level or enabled the Busy Channel Lockout....

If you don't have the user manual to check you can download from the Uniden site.

Not familiar with that particular unit but check the squelch or monitor settings.
Sometimes you can accidently set the level so the Unit thinks the channel is in use and locks you out

No worries mate talk then

I would remove the chip and see if it happens and remove any other mods to get a base line vehicle and see what happens





........... On the move

VSB15 is going through parliament at the moment and it allows for a 50mm increase over OEM to bring it into line with other State based legislation.

Yeah there were only 2 main changes
rear locker
VDS

and a couple of cosmetic ones
chrome ring around the gauges in the instrument cluster
there is no aerial at the front anymore...they moved...

Alternatively run a strip of velcro hook along the bottom edge of the Hema and an alternate strip of Velcro Hoop stuck to the bottom of the Pen holder in front there and it will stand there forever....

G'Day saa3011, welcome to the forum mate. You would have seen some nice places around Brindies....

g'day mate and welcome aboard............. here's to you enjoying the new addition once it arrives

Welcome to the forum mate.

Gday mate welcome aboard gotta friendly mob here fulla great info and advice

G'day mate - welcome aboard. Great people, information and laughs on here mate, so feel free to join in and make the most of it.

Enjoy!!

G'day Mate, Welcome to the forum! Yes, I think it is a great forum. I am new member in the forum but I have been reading it since December and I have learnt lots. I hope the delivery of the new GU...

Welcome to the forum mate, feel free to ask any questions and join in the conversations.