Search:

Car runs like a bag of poo basically. You should clean the MAF at every service anyhow....

OMG. tripllle dupe post. I need to go to bed..

Mate my Troll was doing the exact same thing a while back, would start straight up, run for about 10 seconds and then die.. Would have to crank the motor over and use the primer pump to help start...

He has just got back to me, he's willing to if there are a few to do as it would cost him about $130 for him to get a cluster, unless someone has a crapped out one???

I'm keen, anyone else?
...

I gotta ask this question to satisfy my curiosity.

How do you :driving2: around, knowing, that at any second of any minute of any hour of any day,
your lift kit might get you stopped and...

hey mate, I just put up some pix of my set-up, it is for a Y61 98 wagon but you might get a few ideas.

this is the part that needs replacing www.atocauto.com.au/proddetail.asp?prod=28628_D2700

Mate I think the drawer face is alloy, the carcases are timber

http://4wdstuff.davejones.com.au/subdomain/4wdstuff/Other/construction_of_drawers.pdf

Macca

Made some off these plans, scrolll down page and download plans.
Had them in a dual cab, lasted 5 years without any trouble then sold them on Ebay for $450 when I sold the DC
...

Great project for the little tacker mate...

Here's some DIY threads with instructions and photos mate. Don't forget to ask any questions if you get stuck mate!
...

There is a little check valve in the line near or in the large barn door. This is your culprit

X2 - they'll expand through the centre of the tyre leaving it to wear faster than the outer edges, and having less 'equal traction' on the tyre across its width on the road.

Yeah keep running your hand over the area as you heat. If it starts to get too hot for your hand then it's getting too hot for the paint.
It take stickers off cars regularly (signwriter).

Warm them up with a heat gun or hair dryer. Only hot enough so you can still hold your hand on it. Fingernails are best as they don't scratch or be very careful and lift the edge a little with a...

Definitely posible and many have done it. I think Marks Adaptors do the kit for it . I'm not really sure on the cost but a mate of a mate got a new crate motor and got it fited and cost him $20g's...

G'day mate - Welcome aboard. Great people, information and laughs to be found on the forum, so don't be shy and join to make the most of it.

Enjoy!