Search:

I think the biggest drama you will have is for the kickdown of the auto. The rest should be pretty straight forward. If it was me I would be manualising the valve body and putting in a TC lockup...

Yes they can be bolted to them it has been done not sure what is needed though

x2........

the blocks are the same so I dont see why it wouldnt fit could be wrong though

Benny

I remember someone telling me you can scrub/sand the white to clean/renew the white lettering.
As it comes away to reveal fresh new white.
Need a steady hand one would think.

might have been...

240 grit wet and dry on a sanding block with running water makes quick work of it. I'mm getting some STT's next week I'll let you know.

River crossings and mud tracks works best for me

that black sandy laomy bog we get on the west coast of tas is great for cleaning tyres!

Sneak up on it carefully with the pressure washer, mine says not to use the highest pressure no22le on tyres.

I carelessly ran it over my bare foot once, which is also against the rules in the...

Use a high pressure water blaster at close range, a little bit of degreaser helps too

Thats good
Have they changed the paint .
I had trouble removing it some yrs ago.
It didn't want to come off at all.
Took more like 20 washes and scrubbing and still was visible.
Take it back...

yep....wet it! first wash and its gone bud

Good to here mate:)

Lucas

Silly question, but you haven't thrown a wheel weight have you? A bumpy road and a loose wheel weight could end like this for sure. Check your wheel balance.

nice one mate, look forward to seeing the reuslts