Search:

Well yesterday I finally replaced the leaking factory unit with a Diesel Smart exchange unit. I also installed a catch can in the process and cleaned the MAF so the complete air intake gets a breath...

Yes, as per Treckster's comment about the fuse/breaker. I run a 50A Maxi fuse for my trailer cabling right at the battery end.

Also, when soldering your Anderson Plug lugs, make sure you have...

I got some wire from work, its 5 core 6mm lol, the outer cable is about 20mm od. I run 2 50 amp fuses about 12" off the battery, then ran this through the firewall and down the passenger side to the...

Where do you need it to be?

I ran one to the rear of my vehicle for the trailer, and another into my cargo bay for my fridge. My trailer cabling goes out the engine bay through a grommet into the...

Try this Link Mate

http://www.4wdadventurers.com/showthread.php?568-DIY-Guide-to-Anderson-Plugs

40232I ran mine from the AUX battery to the bulbar via a 30 amp circuit breaker.

Hi mate.

You will probably find some at your local tyre dealer mate. I would advise you to consider replacing the rims on the trailer with 16x8 steel wheels and run tyres with the same rolling...

The manual costs bugger all off ebay. People should join a forum for what a forum is intended to be. Like minded people discussing, enjoying, new friends, sharing ideas etc etc.

Yawwwwwwn........ Sorry guys, just woke up. As has been said before, this topic has been done to death. So what if you get a couple of spammers, there's not that many in the grand scheme of...

It's also been said before, and I agree, that instead of raising the post count how about leaving it at 25 but making a minimum period of 3 months before they are accessible?
Some people just don't...

Give nissanewby a pm he may be able to help if not point you in the right direction

Hi mate - further to what rusty said - if you click on settings up in the top right and on the next page you will see down the left hand side "Edit Signature". Jump in there - type what you want and...

hey mate, its in the signature part of your profile. if you need more directions than that just repost in here and ill guide you through it

Derek at AutoArt Mechanical (India Street, Capalaba) could knock this over for you easily mate - great bloke, good pricing. Tell him Scotty with the Grey GQ sent you there ... actually ... that...

Top effort mate, keep up the good work cos yer a long time dead.
Cheers, the ferret.