I was an automotive painter for over 15 years and from the days when I started my apprenticeship until now I seen a huge change and not for the good. When I started out we where matching just the...
I was an automotive painter for over 15 years and from the days when I started my apprenticeship until now I seen a huge change and not for the good. When I started out we where matching just the...
Hi Everybody, I thought I would post this rather long thread on my experience in searching for an ex Telstra Nissan patrol.
I do this because well….. Basically these rigs are a great work/leisure...
Well that's a good that you are going to block the EGR, this will stop the carbon build up inside the Inlet manifold, step 1
The PCV allows oil vapour to mix with and cause the carbon to stick to...
Id spend a little extra and get a Pure Sine Wave Inverter for peace of mind, it will cost a little more, but you don't have to worry about stuff not working or damaging anything, first Inverter i...
Found a neat little product that I thought I would share.
I have some sail track mounted on the camper which is only about 2.5m long and it came with the usual tiny awning 2.5m x 2.5m which...
Thanks GRA.GU, good info. I've seen the different widths in the genuine Nissan bullbars for DX & ST, but not in the ARB bullbar which is what I have on my DX. It's made for ST so it hangs out either...
Hi matto9018,
It’s very hard to get accurate specs on the oil that Nissan recommend for the ZD30 apart from the JASO DH1, ACEA B3 and the warning not to use API CG-4 rated oil. They do recommend...
I upgraded mine to HID with a 35 watt high/low kit i bought at JAYCAR for $119, the lights are great quality and awesome performance. As far as installing them or even just changing a regular bulb i...
and when you take your seats out, dont forget the water will come seeping through those bolt holes and if like me you have removed the tie down points in the boot and like me havent plugged up the...
If the water is deep enough and you are in it long enough, it'll definitely come up though the floor moulding around the gear levers - if you figure out a way to seal that up, then I'm all ears too...
G'day Mate - Welcome aboard join in when you are ready and have fun mate plenty to do see and if u have any problems just ask and im sure u will get an answer !! Bucket loads of usefull information...
g'day Graeme and welcome aboard mate
Hi and welcome to Nissans Nut House Graeme
Tim
“Women marry men hoping they will change. Men marry women hoping they will not. So each is inevitably disappointed.”
~ Albert Einstein
g`day Graeme
welcom on board mate
heaps of laughs and bucket loads of info here enjoy
nowoolies
Paul
p:s piccies we luv piccies