Search:

A better radius bend bottom pipework setup would have been nicer though if done again!


Sent from my iPhone using Tapatalk

FWIW mine came with an alloy from previous owner (unknown brand) and kept falling apart on the local rough roads. Changed to a local brass for over say 4 years now without issue and are comfortable...

Yes it was through BD cost was $1545, my builder recommended the ADRAD also.
Project P400 is not on the road yet, will get update this week. Has been slow mainly due to commitments on both sides.

Their radiators are brass. My conversion was done 15 mnths ago. They did not offer me an alloy one.

Well my passenger window came off the rails yesterday, hence having to rip the door apart to see whats up. I fixed it and then decided to do all the doors. Those nissan plug things suck.

I once tried browsing that site and had no luck, but the other day I put a part number of one of the parts I was after into google and that website popped up, showing the appropriate section for my...

Hi Ian2011. I have the mirror type camera and have power to the camera only when reverse is selected . I have tinted windows and the rear side windows are blocked out with the silver foil stuff also...

I bought a set of lock nuts ...the same as for driving lights...I drilled out and used 8mm bolts with hex heads...still have to get stainless bolts yet because the black ones rust as you can...

If the bolts are big enough I'd drill and roll pin..
Could also drill a hole in one of the fins and use steel fishing trace and a solid crimp and tie it onto the bar..

Like these ones?

This is what I have used all over my car. We use them in the playground industry.

Yes this could work if you use the high strength retaining compound it would make disassembly quite difficult.

There is an anti tamper torx style which requires a slightly different tool. The difference being the tool has a hole drilled in the centre of the torx and the bolt head has a pin so standard torx...

I normally use torx on majority of accessories but decided to burr the threads but a lot of light bars can be undone from the sides aswell where they pivot so consider that too.

You can get security bolts as well which are similar to a torx head in place of the Allen key. You can also get bolts that can only be done up and with a specific tool if you don't mind having to cut...

Loctite the screws then burr the thread, only way to get them off is to cut them off