Search:

Here is the one I took of my Patrol.

http://www.nissanpatrol.com.au/forums/images/imported/2016/10/291.jpg

I know it’s a Toyota, but I thought this photo was worth sharing, not just for it’s subject, but because of it’s quality. Wish I could take pics like this, but think I’d need a significant camera...

Here's how I've mounted mine, plus a few extra on top of the dash

These make fitting to boost gauge easy,...

But where you've been hasn't really been where you've been so where you thought you were was in fact where you might want to be but haven't been there yet, or have you?

Bumped I used bosch in my 3 ltr no complaints

I was told TJM only do the T13 bar now to suit the series 3, PM sent with price.
I think mine is the T13 Outback bar [see pic] I also have TJM Outback side steps.

It could be the chip fighting the dawes..
Have you had the car tuned to suit both setups and they are working together..
But imo the only maf to use unfortunately is ome..
Others seem to not last...

Gmv upgrade..
Should be a blue sticker in drivers door or next to Vin plate..
A couple of things that happen on the gmv upgrade.
They will bolt some sort of rear tower brace.
And depending on...

If it has been done properly it would be engineered and you would have a plaque on the fire wall or in the drivers door B pillar. You would look for tower braces, diff bracing, rated springs and...

68256
Red square Moscow

68257
Kazakhstan

68258
Kyrgyzstan

68259

Try this thread .... http://www.nissanpatrol.com.au/forums/showthread.php?4007-Disconnecting-GU-quot-key-in-quot-warning-buzzer

There is a single brown wire at the bottom of the steering column near the key.....

Take the plastic surround off the column, and disconnect .... pure bliss again....

Not sure on that fuel cut thingy, A Dawes valve is a manual boost controller with 3 outlets
Check this diagram to see if you have fitted yours correctly, this Chaz is a Guru on all
things ZD30...

Save you welding in a port and at this price you cant go wrong

http://www.ebay.com.au/itm/331875396276?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

So I've noticed a fair few people struggle with finding a nice space to fit the rather large catch cans and I think I may have found the answer and a very simple way to install it..

I wanted to...