Search:

https://www.flickr.com/photos/13765922@N02/sets/72157629319146777/ Try that site. I have found some of the diagrams for the RB30 aren't as they should be, so don't feel left out:)

tuckertrucker The Haynes manual page 16-12 shows the TD42. Yep, just earth the starter relay and bypass the switch altogether as per a manual transmission. I have amended post #3.

The manual pages EL 80 and EL 81 show the relay as 142 M under the cover next to the battery.

Page EL17 shows which wires to bridge out, but the Haynes manual is a bit different.

Edit that is...

P/N inhibitor is on the side of the trans. It closes the circuit in P or N so the start relay can work.

Some of the laws here in Oz are just tax collection in disguise. :), but I guess it happens everywhere more or less.
Unlike in New Zealand, here on Oz, we have slightly different rules and...

One solution of several would be....
Bosch and Delco and probably a few others make a "Series Parallel" switch which would allow you to run your domestic batteries as 12 volt and switch to 24 for...

take a 12v battery box and charge via a solar panel

Had this problem with old 24v Cabstar. In the end I ran 2 x 12v batteries in series as the main 24v supply and tapped into the cable between the batteries to get 12v. Used a 24v relay in the...

.............

70646

Ac idle up. Will go from the switch on the firewall to the white diaphragm that acts on lever for accelerator.

For me it was the wheel bearings. I personally wouldn't touch teh steering box. If theres any play what so ever in the bearings, nip it up.

Sent from my GT-N7105T using Tapatalk

Maybe by renewing a few earth straps in and around the engine bay,
may and a big maybe, ,might help any electrical problem

Mine did a bit, but new mounts eliminated it and made resting on handbrake noise much much better..

For vibrations I'd start with gearbox and engine mounts..
I think it's normally the left hand ones which fail..
But while your at it might aswell change all 4..
Just ensure you have the correct...

I reckon the vibration will be the engine mounts, mine did the exact same thing.