OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 1 of 10 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    6
    Views
    2,887

    [QUOTE=rusty00;725493] Thats a typo. Its...

    Thats a typo. Its supposed to say...
  2. Replies
    5,692
    Views
    1,678,372

    Looks awesome mate.

    Looks awesome mate.
  3. Bored at work. (I'm too tight to buy anything I can make)

    Had some downtime at work last week, and been eyeing off this old air filter with auto drain in the out of service spares rack ( hoarders haven )
    Decided I can make a catch can out of that for a...
  4. Replies
    6
    Views
    2,986

    If you think the diesel fumes are more noticeable...

    If you think the diesel fumes are more noticeable then a remap won't fix it. The oem exhaust has a catalytic converter in it. Does the new exhaust have one? If not then that's probably the reason....
  5. Replies
    6
    Views
    2,986

    I've now had 3 Beaudesert exhausts. Every time...

    I've now had 3 Beaudesert exhausts. Every time there was burning off for a few days. Paint , or gaskets or whatever coating they use ...
    A good tune or chip after exhaust is always good as it can...
  6. Replies
    6
    Views
    2,986

    It may be burning paint etc as it heats up, Go...

    It may be burning paint etc as it heats up, Go the remap every time.
    Have you fitted a boost gauge yet or Scan gauge??
  7. Replies
    28
    Views
    8,776

    A winch can also be used to clear tracks of...

    A winch can also be used to clear tracks of fallen trees, etc. And can be easily set up as a flying fox over swimming holes too.
  8. Replies
    12
    Views
    7,172

    I haven't tried the Mickey T's or Coopers, but I...

    I haven't tried the Mickey T's or Coopers, but I do have approx 15000 k's on my 32x11.5x15 BFG KO2's and I love them.

    My experience has been - No punctures / staking (touch wood)!! and excellent...
  9. Replies
    12
    Views
    7,172

    No probs. 285/75-16 and $350 a corner fitted and...

    No probs. 285/75-16 and $350 a corner fitted and balanced.

    Cheers

    Rainsey


    Sent from my iPad using Tapatalk HD
  10. Replies
    12
    Views
    7,172

    I haven't tried the STMAX, but the old ST's...

    I haven't tried the STMAX, but the old ST's chipped like no other tyre I have tried, so i wont go back there on principle. Marketed as offroad tyres, but not really for offroad.

    My last three sets...
  11. Replies
    12
    Views
    7,172

    On my second set of P3's. Love them. Low noise,...

    On my second set of P3's. Love them. Low noise, and they're aggressive enough to get me through the rough stuff.
  12. Replies
    12
    Views
    7,172

    I run MT ATZs, have taken me lots of places...

    I run MT ATZs, have taken me lots of places including the Simpson, Flinders Ranges, and most of the NT rough tracks. They work well, don't chip or cut much and looked after wear well. Only flats I...
  13. Replies
    4
    Views
    2,607

    I cut and extended my sender float shaft using...

    I cut and extended my sender float shaft using coat hanger wire and solder. So the float drops to the same level as it would in the oem tank. Probably not the best way about it but i did with what i...
  14. Replies
    10
    Views
    22,804

    Another GU rear bar build

    First up - I'm a brand new poster so I'm not fully around all the forum etiquette. Feel feel to give me a kick in the arse and point me in the right direction if I'm to far left of field.

    On to...
  15. Replies
    4
    Views
    2,607

    I didn't bother with that when fitting my Long...

    I didn't bother with that when fitting my Long range aux tank. I dont intend on rolling my car and if i ever did. I think some fuel weeping from the cap would be the last of my worries. Lol. What...
Results 1 to 15 of 138
Page 1 of 10 1 2 3 4