26th November 2014, 09:07 AM
If you have a Super Cheap auto near by, they have the machine to tell you what the code is. I think it cost around $15 for them to plug it in. They can also clear the fault codes too. Blocking the...
26th November 2014, 07:26 AM
Hi, I'm also new to the forum and the ZD30. I've had this once already, don't forget the check engine light on these is also a 'water in fuel' sensor, drain the water out of the fuel filter housing,...
24th November 2014, 07:43 PM
Welcome to the forum mate.
24th November 2014, 06:54 PM
Welcome aboard mate. Enjoy your stay.
24th November 2014, 06:53 PM
I thought about mentioning this too, but I thought the engine light comes on only on the CRD, not Di, if you block the EGR. Somebody correct me if I'm wrong though.
24th November 2014, 04:32 PM
Shucks thanks Clunk........ But it'll never happen man you're toooooooo far off young man
24th November 2014, 03:12 PM
G'day Jack, welcome aboard mate.... Don't worry about Growler, he's a top bloke and I wish I could be just like him
24th November 2014, 03:03 PM
gday jack and welcome its only when growler starts calling people names and deleting their posts that etiquette has been breached
24th November 2014, 02:23 PM
Might want to swap your ign relay [blue] with the aircon relay for a test[Blue]
Photo are in a thread with similar problems, also poor earths are a curse of all GQs and GUs
boost is a tad low IMO...
24th November 2014, 02:18 PM
X 2 welcome to the forum Jack , jump in anytime and enjoy
24th November 2014, 01:19 PM
Posting this introduction is good etiquette - so welcome to the forum Jack.
24th November 2014, 01:09 PM
ok sounds like you need to disconnect the battery for half hr or so to reset the ecu and then it will be playing with the boost to make sure you are not overboosting the engine.
24th November 2014, 07:47 AM
Do you have gauges fitted???
24th November 2014, 01:01 AM
If you have blocked the egr you will get the check engine light but you should get it sorted by doing the daws valve and boost T .
22nd November 2014, 07:27 AM
Hi Jack dis connect to battery for a while see if that helps.
but in the mean time pop over as suggested to the intros
you will get a better response, I dont think the manual would help with this...