13th January 2015, 10:57 PM
If it's for your 2008 gu dx this will helphttp://www.nissanpatrol.com.au/forums/showthread.php?10293-Fitting-rear-seats-to-a-DX-patrol-need-a-bit-of-help-Please/page1
3rd August 2014, 06:44 PM
I got one of the diesel smart ones. ...
3rd August 2014, 06:38 PM
Hi G
I've fitted the cross country
Yes expensive but I'me happy with the slight improvement in acceleration
so for me worth the cost
regards
Joe
15th January 2014, 02:57 PM
Real good to hear all of you are stoked LOL
1st January 2014, 05:20 PM
P4trol, One of the pieces that bolt to the floor has a washer as part of it, the black one in the pic.
Graham I gernied the belts and they look a lot better.
21st December 2013, 01:22 PM
http://www.ebay.com.au/itm/Manifold-001-complete-Air-compressor-ARB-Endless-Air-TJM-on-board-4wd-pneumatic-/290971558382?pt=AU_Car_Parts_Accessories&hash=item43bf41a1ee
Here an example of whats...
20th December 2013, 02:22 PM
You'll need an air manifold with a one way valve near your compressor.
You should be able to run air tools with what you have in mind.
Pic is of manifold you need not the fittings.
System is no...
20th December 2013, 02:00 PM
I am now ditching that set up in favour of an endless air set up...
I have diagrams somewhere I did when I made my set up... see if I can find them.
This is from 04off, he did me this diagram...
6th December 2013, 01:45 PM
A couple of members here may have the Ute parts you need .
Cuppa rings a bell as he recently fitted bucket seats to his ute,
Might be worth a PM to see if he has anything left over
6th December 2013, 12:57 PM
It will go straight in. The handbrake lever goes between the 2 seats as its a 3/4 seat. You will lose your centre console and the handbrake and gearstick surrounds are different but you could run...
14th November 2013, 02:57 PM
Check out Diesel Smart who are a sponsor here.
I just replaced mine with a fully tigged job.
Highly recommend, one of the cheaper options
going around and warranty as well.
PM them for price...
30th October 2013, 09:23 PM
Between June 2006 and July 2013.
https://www.recalls.gov.au/content/index.phtml/itemId/1051841
30th October 2013, 04:08 PM
JOB DETAILS PRICE QTY/HRS AMOUNT
JOB 3 RECALL R1306 ACCELERATOR PEDAL NO CHARGE
PRT A8002VS41B LEVER COMPLETE-ACCEL 1 NO CHARGE
PRT 18020VS40A BRACKET-ACCEL P 1 NO CHARGE
PRT 24028VV29A...
8th December 2012, 07:39 PM
Get onto Nizzbits mate and order one it takes 3-4 days to get it, although i am northern nsw, they are out of melbourne, i rang nissan and they wanted $550, mine cost $440 plus $20 for the postage,...
26th November 2012, 08:01 AM
grimace
my 08 wagon was doing the same, would drive ok if i put the boot into it, but sitting around 2000 revs in 2nd, 3rd it would surge (traffic driving). also really nasty in low 4. tried all...