Search:

Mate between the two tanks as long as it pumps is no problem and as you say the xr6t will need an upgraded pump.

:thumbup:
I recently increased my Sub Tank recovery from 28l to 34l by modifying the sender float arm and the fuel pick up
I bent both (well straightened more like by around 40mm)
I removed the...

This is the Mann Hummel Provent 200 PCV filter that myself and a lot of others have fitted to our Patrols.

http://i758.photobucket.com/albums/xx224/tonyh01/HBGCLRica_a.jpg

On the main unit...

One of the major causes of early build ZD30 engine failures was PCV (positive crankcase ventilation) oil vapours travelling back up the inlet ducting after engine shut down. This oil mist eventually...

Sling Load Angle is the angle the legs of the sling form against the direction of the applied force.

Many people assume that as soon as an ES or Bridle is introduced then the applied force is...

I would say you get what you pay for after looking at these prices

http://www.marks4wd.com/products/CV%20Joints/cv%20page.htm
...

The CV with surface rust on the balls I would be replacing, the rough surface will cause accelerated wear within the CV.
The hot spots on both CV cases also has me a bit worried as this could be a...

Gday folks, so the other weekend i changed swivel hub seals. Was cleaning everything up and have decided to change the wheel bearings. (next payday) So am cleaning and repacking my CV's with new...

Hi there all, just found this article Compiled by the Australian 4WD Industry Council in conjunction with the 4WD Industry, it deals with the safe use of snatch straps.


GUIDELINES FOR SAFE USE...

- Use the same "walking" method to remove the turbine seal from the turbine shaft.

http://i239.photobucket.com/albums/ff165/jusmx141/T3%20Rebuild/T3Rebuild16.jpg

- Here is the turbo...