Search:

how old is the thermostat . if it is the original one it may be stuffed , only opening up enough for normal running but when you load it up it may not open any further as required so the engine...

Yes the ones in the wheel arches.

The factory gauges aren't that great and even though it's at 3/4 it could only be at 90 degrees. An aftermarket one would be a good addition.

Try the hose...

What condition is your fan in? Also the viscous hub.

Is there much debris in the condenser effecting air flow? Also are all the inner guard rubbers and othe foam strips etc in place around the...

either get this radiator rodded or replace your thermostat with an OE one.
how is your boost?

Hello Fakeofregbo,
I would think as long as the nuts are the same as the original ( ie nuts with a flange )and same grade bolts it would be ok to use loctite and tighten them up to the recommended...

Where are you located? I have a full set.

I would use a spring washer and loctite if it were me. You don't intend of removing it again...