So the old barn door trims were looking a bit second hand so I decided to make my own.
Came up pretty good I think.
https://uploads.tapatalk-cdn.com/20250421/1c59826297760dbca97ef7a4112598fc.jpg...
So the old barn door trims were looking a bit second hand so I decided to make my own.
Came up pretty good I think.
https://uploads.tapatalk-cdn.com/20250421/1c59826297760dbca97ef7a4112598fc.jpg...
88670
Enjoy the rainbow and my patrol!
Thanks I am now running a 60L Engel from the 1980's - still kicking aftr a heart transplant in 2000, and more recently a Bushman 15L as a freezer. The combo will work well, however if a unit could be...
Low gas will stop the compressor from engaging. It did in mine...
The terminal on the clutch will test as negative because it has a low resistance coil connected to ground/negative. A small spark would be expected when connected to battery positive, and that...
This is a very odd fault, reverse polarity all by itself??? Have you been doing any wiring or switch work under the dash, had the a/c switch disconnected and then re-connected? Have you tried the...
After scrolling through the workshop manual, depending on your setup it could be a few things like a loose connector, faulty Engine Control Module or faulty relays. With the drive belt loose and If...
So I have decided to make my own dual Jerry can holder for the rear bar. But. Have the holder running front to back rather than the usual left to right.
This way the swing away bar is not too long...
RIP Whitie. Not a dog but our pet goat that acted as if she were a dog. We bought her and her daughter in 2004-5. They were both pregnant, so we think Whitie was around three to four years old when...
It's very satisfying when aftermarket things fit perfectly :D
http://www.nissanpatrol.com.au/forums/images/imported/2023/10/51.jpg
Gave the old GUrl a quick scrub before getting her dirty over a 4 day Fecking weekend starting this Friday at Enoch’s point on...
87345
87346
87347
Bloody hell! very nice!
Also loved the fact that the tire swing pivots with the door and not by itself. That side of the swing you need not worry with undone latches! Really inspiring!
Well done mate. Top notch work done. I widh my welding was neat like that.