Search:

Hi John,

Undo the two 10mm Bolts as seen from the inside panel removal. Then pull lights straight back towards the rear as there are also three clips in the body, that hold plastic balls on posts...

its not that hard I used a 20mm diamond drill [cheap to drill the holes for the new sockets.
Try Patrolapart for the loom, comes with instructions, I have LED and its a great affect IMO
behind the...

After market lights are available, but appears that some electrical work may be required to get them working....

you can buy a loom with sockets to suit the Dummy lights about $90 from memory,
Be carefull drilling holes for new sockets plastic bits will fill the lens, but can blow out most with an air hose...

Lets hope that fixes it for you John .... don't despair, as there are thousands of these running around quite well ....

I am sure that they will get to the bottom of it, and for your sake, I hope...

OK so i just went out and took some pictures hope it helps you
Thought i better do it not or i forget tomorrow lol

http://i193.photobucket.com/albums/z180/bushytas/10062012323.jpg
...

Hi Superoo
I’ve replaced my rear light and wired them in about a year ago.

Now what you want to do I very easy I will try and get some pictures tomorrow to help you do what you want to do
But...

This pic shows the position of the Mass Air Flow sensor (on my ZD30) on the top of the air filter housing. Shown here with the wiring cover removed....