G'day mahse. I have looked at the wiring diagram. If it is a 12 volt system, the red wire on the coil should have 12 volts on start up and should be reduced to run through a resistor when the engine...
G'day mahse. I have looked at the wiring diagram. If it is a 12 volt system, the red wire on the coil should have 12 volts on start up and should be reduced to run through a resistor when the engine...
The gap with stand points is too wide - the extended rotar button helps.
I would consider a carby kit, you could have some blocked jets -
Also set the tappets they should be a little bit noisy