Search:

Well i woud like to say here that if you take out a shine connect and hit it with a cable fan it should have 24v imprinted on it or the area rover is a 12v program and your losing a beginner engine,...

Hi Lionel,
The motor is Nissan SD33NA, the adaptor is Nissan, the clutch....dunno.. the box, well it looks unlike any Nissan box I know of, I am guessing it's a Landrover box of some sort.
Cheers,...

Rod and Rodney, to 2 Roddys lol.
Two of the best, good work guys helpin out Lionel, Well done.

Hi-jack
Love reading both of your knowledge, haha if that makes sense (I love scotch)
You both...

A few bits and pieces and you will be up and running in no time at all .....

Hi Lionel,
From what I can see, this is a very early SD33 NA., about 1980, the gearbox is not Nissan as is the transfer, the clutch could be anything, I'd say the Rover master cylinder would do the...

Injector pump control rod missing, Dash pot (vacuum controlled) missing from bracket next to inlet.
I would be hoping the inside of injector pump is better than the outside, and that as it has a...

The thing is Lionel, does yours have a rod or a cable?, rod is 24 and cable is 12v, but if it's 12v it would most likely have a turbo!
Cheers the ferret.

Hi Lionel,

I can help you regarding the wiring side..........hell, I've even been involved with two complete L/R rebuilds.

Mr Ferret is the best person to speak to regarding the mechanical...

Yeppum, that's the Edic motor, SD 33 non turbo 24V, darn!!
When you turn the key on, the motor moves a rod at the injector pump, firstly to "start" position then to "run", when you turn key off, it...

Hi Lionel,

I'm not sure what the Gregory's manual call it, but "control motor" sounds feasible. You are better off installing a manual cable if possible.

Where abouts in QLD are you?

Sorry,...

Nah, I'm here fer good Rodney,
I do get pleasure out of helping others tho, as I'm sure you do.
Cheers, the ferret.

Hey Rod, I'm not doing too bad. I try to keep the blinders on as much as possible these days.

Your boat setup was the first thing that I thought of when I first read this thread.

Good to see...

Hi Rodney, how's it going Mate?
I have an SD33 NA in the boat, it was 24V, is now 12V, and I have a cable with a 3 position Detent to operate the injector pump, pain, but better than the Edic motor...

I've been hoping you would see this thread.

If his engine does have an edic motor can he remove it and fit a manual start/stop cable?

Hi Lionel,

Yeah an auto elec will be able to test it for you. You are also going to need a regulator if you use that alternator.

You really want to stay away from a split 12/24 volt system if...