OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 1 of 5 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    9
    Views
    4,964

    Start at the hose connected to the turbo actuator...

    Start at the hose connected to the turbo actuator and work back to the vacuum pump located on the front of the engine. Also - there are vacuum hoses connected to solenoids under the intercooler. ...
  2. Replies
    9
    Views
    4,964

    ^^^^^This... ....and this. Boost leak 100%. ...

    ^^^^^This...

    ....and this.
    Boost leak 100%.

    And no need to stretch the spring in the dawes anymore. This issue was corrected with a stronger spring about 3 years ago. Unless you have one of...
  3. Replies
    9
    Views
    4,964

    Sounds like it could be a vacuum problem to me. ...

    Sounds like it could be a vacuum problem to me. Soapy water won't show a vacuum leak. Usually the hoses split in the most difficult to see spot. You will have to check the hoses one at a time.
  4. Replies
    9
    Views
    4,964

    What intercooler do you have, if its the OE one...

    What intercooler do you have, if its the OE one chances are its leaking.
    easy to check if its oily its leaking
  5. Replies
    9
    Views
    4,964

    ZD30 ... Low boost

    Egr stuck open? Unless it’s blocked that is.
    Otherwise check all turbo and intercooler pipework for loose hose clamps, boost gauge lines, intercooler etc for leaks
  6. Replies
    18
    Views
    29,080

    Just remove and refit. Sent from my SM-P600...

    Just remove and refit.

    Sent from my SM-P600 using Tapatalk
  7. Replies
    18
    Views
    29,080

    I heard some of the Members from OS remove the...

    I heard some of the Members from OS remove the TPS and drill {carefully]
    a small hole in it and squirt with CRC or similar with good results, di for new learningsconnect the battery
    while you do...
  8. Replies
    18
    Views
    29,080

    Hey mate. Nissan recalled the pedals/TPS on...

    Hey mate.
    Nissan recalled the pedals/TPS on some VIN ranges. Yours is out of date range, but I know for a fact some 2005 are affected, as my workmates early 2005 was done free of charge by nissan....
  9. Replies
    6
    Views
    3,507

    And this is what I've done with an On/off/on...

    And this is what I've done with an On/off/on Switch at the back.
    49417
  10. Replies
    6
    Views
    3,507

    Here is Mudunners diagram. 49415

    Here is Mudunners diagram.
    49415
  11. Replies
    6
    Views
    3,507

    I have my setup so that when I select reverse it...

    I have my setup so that when I select reverse it will come on with my reverse lights. Also have wired in a switch on the dash so that I can remotely turn it on, but the reverse lights come on too. No...
  12. Replies
    11
    Views
    4,359

    All manufacturers make their radio sets suitable...

    All manufacturers make their radio sets suitable for a frequency range, lets say ABC Company makes one that will hypothetically work on any frequency between 400 to 500 Mhz.
    All countries around the...
  13. Replies
    11
    Views
    4,359

    5 watt is legal and there is a commercial...

    5 watt is legal and there is a commercial strength that requires a licencei think that is like 25watt? i think but if you buy from china you could get a 50watt
  14. Replies
    11
    Views
    4,359

    CB is licenced to 5w maximum TX power, some...

    CB is licenced to 5w maximum TX power, some people get commercial radios and program CB frequencies in and run 25w TX power.
    It is a dumb thing to do as you will transmit further but the other radio...
  15. Replies
    11
    Views
    4,359

    and this is what it will end up like...

    and this is what it will end up like
    43153[ATTACH=CONFIG]43154
Results 1 to 15 of 66
Page 1 of 5 1 2 3 4