Search:

Id recommend an adrad brass/copper unit off eBay. Can be had for the $300 mark and it's a quality Australian made radiator. Avoid the cheap alloy radiators from eBay, I've gone through 2 within 6...

I just rubbed some oil on the outer side of the bearing cup. Putting them in the fridge would help too... Just don't put your hub seal in back to front. It will still seal but after a week it will...

I use a steel pin punch and hammer to get them out, the bearings are hardend steel so you won't hurt them. Just keep alternating where you tap on the bearing so it comes out evenly, same fitting the...

No your not mate. The nut is what the screws actually screw into. Its round like the washer with the holes in it. Otherwise the screws wouldn't be there as they have nothing to screw into.

See the...

As long as the bearing is not like a cock in a sock it should be o.k. New bearings and seal, plenty of hi-temp grease and you'll be set.
When installing, nip it up just until there is no play. As...

AJ,

If the hubs are unlocked, they are just spinning freely on the wheel bearings ....

Locking the Hubs will lock the hub to the axle, and spinning the wheel will then turn the axle.


I...

OK AJ,
Jack up the front wheels, leave them unlocked and spin one at a time, and listen for grinding noises. That will give you an idea if it is in one of the wheel bearings or brakes.

If nothing...

Mate I went driving last year and camped as well for 3 days and everyday we stopped and set up camp I put a blanket then a tarp over the bonnet while the engine was hot, when I woke in the morning...

As long as your coolant is green / red / blue it should be OK for Hotham. If in doubt just put an old sack over the radiator of a night. You WILL NEED ALPINE FUEL!!! Get it at the servo in Bright...

The front diff I was working on for this article was out of a GQ Patrol and was fitted with Nissan manual hubs. The job is the same on GU Patrol with only minor differences in the hub nut area.
...