Search:

I only recently installed dawes and needle valve. ( blocked egr ) . better boost curve . no lagging . you can get all these parts off Mudski . It took a while to fiddle with , but once it was set...

I'd rather that than the position I'm getting into.

Filled her up with diesel.
164.93 litres @ $1.449
Bloody hell running in fumes.

Save some cash and weight, use a nylon wear strip called UHMW. Should be able to get it from any good fastener or bearing joint. A strip on the draw and a strip on the sub frame and they slide like...

well this is interesting... on thursday the 20th of june i will be doing my usual 1400k trip from Newman to Kalbarri via Coral Bay.
i normally get about 14 ltr per 100k and the last trip was after a...

OK so the past three weeks i have had to drive 400km intrastate and i figured i would do a little test.

I figured i would see if turning the snorkel intake to point backwards made a difference...

I have one of those adaptors. Its at the front of the intercooler. Easy to see once you take off the engine cover and bolts in works great

Those TurboSmart boost controllers wont work with the ZD30 turbos as the VNT on the turbo is vacuum operated not boost operated like nearly every other turbo'd vehicle.
You must use a Dawes for...

G`day guys
I`ve been doing Geocashing for around 8 to10 years now on both the world and Aust sites.
Have found some very interesting places which I would not have gone to if not for this sport ....

Hi Simon,

There should be someone from up your way willing to give you a hand I hope.

The first thing you could try, is to temporarily swap your MAF over with your brother in law's, if his is...

Has your brother in law got a series 3 or 4? ( does it look identical to your or the updated and current wheel flares and slightly newer shape)

Does he also have a Common Rail ZD30 CRD? If he...

Yes you have it wrong. Your boost gauge needs to in the boost side, not the vac side. Anywhere after the turbo and before the inlet manifold you can put it. You will need to get a fitting welded in...

hi and welcome to the forum a great mob of people here and a lot of very usefull information
best wishes with your patrolling
stephen

welcome. for me, this is the best forum on the net by far. if you're a patrol fan that is.

Next I'd be fitting an EGT and Boost guage to monitor all your mods.
You'll need a needle valve from Dependable Distributors in Adel if your fitting
Full NADs kit.
A chip an exhaust can see gains...